Had issues with it reporting wrong garage door status on the phone app.
Mimolite garage door smartthings.
Mimolite wiring diagram for garage door application.
Does anyone have the actual device code for the mimolite garage door controller.
Mimo2 installation instructions.
See mimolite for garage door and magnetic door contact this worked find except sometimes the close open event would get missed.
Based on todd wackford s mimolite garage door opener metadata automatically generated.
So i was hoping to change the icons and.
Flow meter guide with smartthings.
In the routine.
So far this is what i ve done.
I have a set up a mimolite to open and close a garage door.
The mimolite module is an interface bridge module capable of converting a digital or analog voltage input and or a z wavetm rf message input to a dry contact relay output and or a z wavetm rf message output.
Mimolite comes in a plastic enclosure for indoor use only.
Mimolite installation guide for smartthings.
Make future change here.
Fortrezz say the hardware is goo it is a device handler problem.
The tile in my device type actuates the mimolite to open close the door but it doesn t reflect the state of the door so i created a virtual.
Connect one wired devices.
Next i set up a routine to turn on the garage light and open the garage door.
The mimolite garage door device type will allow me to open and control the garage door in the things section although the state is not correct and the configure button does nothing.
Dantheman2865 committed nov 2.
Contribute to fortrezz smartthings development by creating an account on github.
Initially i got the solution that johnconstantelo developed working with a magnetic switch that triggered when the door closed.
If i go to the ide and add a device by selecting from template and then select mimolite garage door controller the code doesn t load or show up like other devices.
Mimolite installation instructions for vera controllers.
In the things menu i can read the current door status as well as open and close the door.
Smartthings say the device handler is not supported.
I have a regular sears door opener with a button that either opens or closes the door.
I don t know if this is linked to current reports.
I would like to use a mimolite to open close and provide the status of a garage door via smartthings.
I have mimolite garage door controller set as the device type.
Mb323 i wish i would have seen this thread earlier because i wrote one a long time ago that i ve been using that i could have shared it uses the magnetic contact similar to post 3 above and it also notifies if when the mimolite looses power.
I was hoping to make changes to how this works for my case as i want it to control a gate.
The mimolite is not supported by smartthings.
Got stuck between the two and finally gave up and returned the product.
A switch on the door tells mimolite the current door status open or closed.
In doors and locks i can get it to show me the correct state i m just using a smartthings open close sensor however tapping the button does nothing.
I have added this device handler to my ide.
